H3C S5120-SI Series

1-13
Examples
# Configure the interface GigabitEthernet 1/0/1 to work in full-duplex mode.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] duplex full
flow-control
Syntax
flow-control
undo flow-control
View
Ethernet port view
Default Level
2: System level
Parameters
None
Description
Use the flow-control command to enable flow control on an Ethernet port.
Use the undo flow-control command to disable flow control on an Ethernet port.
By default, flow control on an Ethernet port is disabled.
The flow control function takes effect on the local Ethernet port only when it is enabled on both the local
and peer devices.
Examples
# Enable flow control on interface GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] flow-control
flow-interval
Syntax
flow-interval interval
undo flow-interval