2-6
Examples
# Specify the ARP packet rate on GigabitEthernet1/0/1 as 50 pps, and exceeded packets will be
discarded.
<Sysname> system-view
[Sysname] interface GigabitEthernet 1/0/1
[Sysname-GigabitEthernet1/0/1] arp rate-limit rate 50 drop
ARP Detection Configuration Commands
arp detection enable
Syntax
arp detection enable
undo arp detection enable
View
VLAN view
Default Level
2: System level
Parameters
None
Description
Use the arp detection enable command to enable ARP detection for the VLAN.
Use the undo arp detection enable command to disable ARP detection for the VLAN.
By default, ARP detection is disabled for a VLAN.
Examples
# Enable ARP detection for VLAN 1.
<Sysname> system-view
[Sysname] vlan 1
[Sysname-Vlan1] arp detection enable
arp detection mode
Syntax
arp detection mode { dhcp-snooping | dot1x | static-bind }
undo arp detection mode { dhcp-snooping | dot1x | static-bind }
View
System view
To Next Page
Loading...
Need help?
General