H3C S5120-SI Series Command Reference

1-2
Table 1-1 display snmp-agent community command output description
Field Description
Community name
Community name.
z If a community name is created by using the snmp-agent
community command, the community name will be
displayed.
z If a community name is created by using the snmp-agent
usm-user { v1 | v2c } command, the user name will be
displayed.
Group name
SNMP group name.
z If a community name is created by using the snmp-agent
community command, the group name and the community
name are the same, which means the community name will
be displayed.
z If a community name is created by using the snmp-agent
usm-user { v1 | v2c } command, the name of the group to
which the user belongs will be displayed.
Acl
The number of the ACL in use.
After an ACL is configured, only the Network Management
Station (NMS) with the IP address that matches the ACL rule
can access the device.
Storage-type
Storage type, which could be:
z volatile: Information will be lost if the system is rebooted
z nonVolatile: Information will not be lost if the system is
rebooted
z permanent: Information will not be lost if the system is
rebooted. Modification is permitted, but deletion is forbidden
z readOnly: Information will not be lost if the system is
rebooted. Read only, that is, no modification, no deletion
z other: Other storage types
display snmp-agent group
Syntax
display snmp-agent group [ group-name ]
View
Any view
Default Level
1: Monitor level
Parameters
group-name: Specifies the SNMP group name, a string of 1 to 32 characters, case sensitive.
Description
Use the display snmp-agent group command to display information for the SNMPv3 agent group,
including group name, security model, MIB view, storage type, and so on. Absence of the group-name
parameter indicates that information for all groups will be displayed.

H3C S5120-SI Series Specifications

General

Brand	H3C
Model	S5120-SI Series
Category	Switch
Language	English