1-23
View
System view
Default level
2: System level
Parameters
interval: LLDPDU transmit interval, in the range 5 to 32768 (in seconds).
Description
Use the lldp timer tx-interval command to set the LLDPDU transmit interval.
Use the undo lldp timer tx-interval command to restore the default.
By default, the LLDPDU transmit interval is 30 seconds.
Examples
# Set the LLDPDU transmit interval to 20 seconds.
<Sysname> system-view
[Sysname] lldp timer tx-interval 20
lldp tlv-enable
Syntax
lldp tlv-enable { basic-tlv { all | port-description | system-capability | system-description |
system-name } | dot1-tlv { all | port-vlan-id | protocol-vlan-id [ vlan-id ] | vlan-name [ vlan-id ] } |
dot3-tlv { all | link-aggregation | mac-physic | max-frame-size | power } | med-tlv { all | capability |
inventory | location-id { civic-address device-type country-code { ca-type ca-value }&<1-10> |
elin-address tel-number } | network-policy | power-over-ethernet } }
undo lldp tlv-enable { basic-tlv { all | port-description | system-capability | system-description |
system-name } | dot1-tlv { all | port-vlan-id | protocol-vlan-id | vlan-name } | dot3-tlv { all |
link-aggr
egation | mac-physic | max-frame-size | power } | med-tlv { all | capability | inventory |
location-id | network-policy | power-over-ethernet } }
View
Layer 2 Ethernet port view, port group view
Default level
2: System level
Parameters
all: Advertises all the basic LLDP TLVs, all the IEEE 802.1 organizationally specific LLDP TLVs, or all
the IEEE 802.3 organizationally specific LLDP TLVs when the all keyword is specified for basic-tlv,
dot1-tlv, or dot3-tlv; or advertises all the LLDP-MED TLVs except location identification TLVs when the
all keyword is specified for med-tlv.
basic-tlv: Advertises basic LLDP TLVs.
port-description: Advertises port description TLVs.
To Next Page
Loading...
Need help?
General