1-11
undo link-aggregation mode
View
Layer 2 aggregate interface view
Default Level
2: System level
Parameters
None
Description
Use the link-aggregation mode dynamic command to configure an aggregation group to work in
dynamic aggregation mode.
Use the undo link-aggregation mode command to restore the default.
By default, an aggregation group works in static aggregation mode.
To change the aggregation mode of an aggregation group that contains member ports, remove all the
member ports from the aggregation group first.
Examples
# Configure the aggregation group corresponding to Bridge-Aggregation 1 to work in dynamic
aggregation mode.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] link-aggregation mode dynamic
port link-aggregation group
Syntax
port link-aggregation group number
undo port link-aggregation group
View
Ethernet port view
Default Level
2: System level
Parameters
number: Number of the aggregate interface corresponding to an aggregation group, in the rang of 1 to
26
Description
Use the port link-aggregation group command to assign the current Ethernet interface to the
specified aggregation group.
To Next Page
Loading...
Need help?
General