EasyManuals Logo

H3C S5120-SI Series Command Reference

H3C S5120-SI Series
910 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #481 background imageLoading...
Page #481 background image
2-21
View
RADIUS scheme view
Default Level
2: System level
Parameters
ip-address: IPv4 address of the secondary accounting server, in dotted decimal notation. The default is
0.0.0.0.
port-number: UDP port number of the secondary accounting server, which ranges from 1 to 65535 and
defaults to 1813.
Description
Use the secondary accounting command to specify the secondary RADIUS accounting server.
Use the undo secondary accounting command to remove the configuration.
By default, no secondary RADIUS accounting server is specified.
Note that:
z The IP addresses of the primary and secondary accounting servers cannot be the same. Otherwise,
the configuration fails.
z The RADIUS service port configured on the device and that of the RADIUS server must be
consistent.
z You can use the commands to change the settings only when no user is using the RADIUS
scheme.
Related commands: key, radius scheme, state.
Examples
# Specify the secondary accounting server for RADIUS scheme radius1.
<Sysname> system-view
[Sysname] radius scheme radius1
[Sysname-radius-radius1] secondary accounting 10.110.1.1 1813
secondary authentication (RADIUS scheme view)
Syntax
secondary authentication ip-address [ port-number ]
undo secondary authentication
View
RADIUS scheme view
Default Level
2: System level

Table of Contents

Other manuals for H3C S5120-SI Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the H3C S5120-SI Series and is the answer not in the manual?

H3C S5120-SI Series Specifications

General IconGeneral
BrandH3C
ModelS5120-SI Series
CategorySwitch
LanguageEnglish

Related product manuals