1-2
Parameters
max-user-number: Maximum number of users using the current username, in the range 1 to 1024.
Description
Use the access-limit command to enable the limit on the number of user s using the current username
and set the allowed maximum number.
Use the undo access-limit command to remove the limitation.
By default, there is no limit to the number of users using the same username.
Note that:
z The access-limit command takes effect only when local accounting is configured.
z This limit is not effective for FTP users because accounting is not available for FTP users
Related commands: display local-user.
Examples
# Enable the limit on the number of users using the username abc and set the allowed maximum
number to 5.
<Sysname> system-view
[Sysname] local-user abc
[Sysname-luser-abc] access-limit 5
access-limit enable
Syntax
access-limit enable max-user-number
undo access-limit enable
View
ISP domain view
Default Level
2: System level
Parameters
max-user-number: Maximum number of users, in the range 1 to 2147483646.
Description
Use the access-limit enable command to enable the limit on the number of users in an ISP domain and
set the allowed maximum number. After the number of users reaches the maximum number allowed, no
more users will be accepted.
Use the undo access-limit enable command to restore the default.
By default, there is no limit to the number of users in an ISP domain.
As user connections may compete for network resources, setting a proper limit to the number of users
helps provide a reliable system performance.
To Next Page
Loading...
Need help?
General