1-1
1 Commands for Logging into an Ethernet Switch
Commands for Logging into an Ethernet Switch
activation-key
Syntax
activation-key character
undo activation-key
View
AUX interface view
Default Level
3: Manage level
Parameters
character: Shortcut key for starting terminal sessions, a character or its ASCII decimal equivalent in the
range 0 to 127; or a string of 1 to 3 characters.
Description
Use the activation-key command to define a shortcut key for starting a terminal session.
Use the undo activation-key command to restore the default shortcut key.
You can use a single character (or its corresponding ASCII code value in the range 0 to 127) or a string
of 1 to 3 characters to define a shortcut key. In the latter case, the system takes only the first character
to define the shortcut key. For example, if you input an ASCII code value 97, the system will set the
shortcut key to <a>; if you input the string b@c, the system will set the shortcut key to <b>.
You may use the display current-configuration command to verify the shortcut key you have defined.
By default, pressing Enter key will start a terminal session.
Examples
# Set the shortcut key for starting terminal sessions to <s>.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] user-interface aux 0
[Sysname-ui-aux0] activation-key s
To verify the configuration, do the following:
# Exit the terminal session on the aux port, and enter <s> at the prompt of “Please press ENTER”. You
will see the terminal session being started.
[Sysname-ui-aux0] return
<Sysname> quit
To Next Page
Loading...
Need help?
General