1-9
[Sysname-Bridge-Aggregation1] enable snmp trap updown
interface bridge-aggregation
Syntax
interface bridge-aggregation interface-number
undo interface bridge-aggregation interface-number
View
System view
Default Level
2: System level
Parameters
interface-number: Layer 2 aggregate interface number, in the range of 1 to 26.
Description
Use the interface bridge-aggregation command to create a Layer 2 aggregate interface and enter the
Layer 2 aggregate interface view.
Use the undo interface bridge-aggregation command to remove a Layer 2 aggregate interface.
Upon creation of a Layer 2 aggregate interface, a Layer 2 aggregation group numbered the same is
created automatically. Removing the Layer 2 aggregate interface also removes the Layer 2 aggregation
group. At the same time, the member ports of the aggregation group, if any, leave the aggregation
group.
Examples
# Create Layer 2 aggregate interface Bridge-Aggregation 1 and enter its view.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1]
lacp port-priority
Syntax
lacp port-priority port-priority
undo lacp port-priority
View
Ethernet port view
Default Level
2: System level
To Next Page
Loading...
Need help?
General