1-29
display cluster
Syntax
display cluster
View
Any view
Default Level
1: Monitor level
Parameters
None
Description
Use the display cluster command to display the information of the cluster to which the current device
belongs.
Note that this command can be executed on the management device and member devices only.
Examples
# Display the information of the cluster to which the current device belongs on the management device.
<aaa_0.Sysname> display cluster
Cluster name:"aaa"
Role:Administrator
Management-vlan:100
Handshake timer:10 sec
Handshake hold-time:60 sec
IP-Pool:1.1.1.1/16
cluster-mac:0180-c200-000a
No logging host configured
No SNMP host configured
No FTP server configured
No TFTP server configured
2 member(s) in the cluster, and 0 of them down.
# Display the information of the cluster to which the current device belongs on a member device.
<aaa_1.Sysname> display cluster
Cluster name:"aaa"
Role:Member
Member number:1
Management-vlan:100
cluster-mac:0180-c200-000a
Handshake timer:10 sec
Handshake hold-time:60 sec
Administrator device IP address:1.1.1.1
To Next Page
Loading...
Need help?
General