1-29
Parameters
None
Description
Use the terminal debugging command to enable the display of debugging information on the current
terminal.
Use the undo terminal debugging command to disable the display of debugging information on the
current terminal.
By default, the display of debugging information on the current terminal is disabled.
Note that:
z The debugging information is displayed (using the terminal debugging command) only after the
monitoring of system information is enabled on the current terminal first (using the terminal
monitor command).
z The configuration of this command is valid for only the current connection between the terminal and
the device. If a new connection is established, the display of debugging information on the terminal
restores the default.
Examples
# Enable the display of debugging information on the current terminal.
<Sysname> terminal debugging
Info: Current terminal debugging is on.
terminal logging
Syntax
terminal logging
undo terminal logging
View
User view
Default Level
1: Monitor level
Parameters
None
Description
Use the terminal logging command to enable the display of log information on the current terminal.
Use the undo terminal logging command to disable the display of log information on the current
terminal.
By default, the display of log information on the current terminal is disabled.
Note that:
To Next Page
Loading...
Need help?
General