1-7
NTDP Configuration Commands
display ntdp
Syntax
display ntdp
View
Any view
Default Level
1: Monitor level
Parameters
None
Description
Use the display ntdp command to display NTDP configuration information.
Examples
# Display NTDP configuration information.
<Sysname> display ntdp
NTDP is running.
Hops : 4
Timer : 1 min
Hop Delay : 100 ms
Port Delay: 10 ms
Last collection total time: 92ms
Table 1-2 display ntdp command output description
Field Description
NTDP is running NTDP is enabled globally on the local device.
Hops Hop count for topology collection
Timer
Interval to collect topology information (after the cluster is
created)
disable
Indicates the device is not a management device and unable to
perform periodical topology collection
Hop Delay
Delay time for the device to forward topology collection
requests
Port Delay
Delay time for a topology-collection request to be forwarded
through a port
Last collection total time Time cost during the last collection
To Next Page
Loading...
Need help?
General