H3C S5120-SI Series

1-23
Examples
# Specify the source IP address for Telnet packets.
<Sysname> system-view
[Sysname] telnet client source ip 129.102.0.2
# Remove the source IP address configured for Telnet packets.
[Sysname] undo telnet client source
telnet server enable
Syntax
telnet server enable
undo telnet server enable
View
System view
Default Level
3: Manage level
Parameters
None
Description
Use the telnet server enable command to make the switch to operate as a Telnet Server.
Use the undo telnet server enable command disable the switch from operating as a Telnet server.
By default, a switch does operate as a Telnet server.
Examples
# Make the switch to operate as a Telnet Server.
<Sysname> system-view
[Sysname] telnet server enable
% Start Telnet server
# Disable the switch from operating as a Telnet server.
[Sysname] undo telnet server enable
% Close Telnet server
terminal type
Syntax
terminal type { ansi | vt100 }
undo terminal type
View
User interface view