1-24
Default Level
2: System level
Parameters
ansi: Specifies the terminal display type to ANSI.
vt100: Specifies the terminal display type to VT100.
Description
Use the terminal type command to configure the type of terminal display .
Use the undo terminal type command to restore the default.
Currently, the system support two types of terminal display : ANSI and VT100.
By default, the terminal display type is ANSI. The device must use the same display type as the terminal.
If the terminal uses VT 100, the device should also use VT 100.
Examples
# Set the terminal display type to VTY 100.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] user-interface vty 0
[Sysname-ui-vty0] terminal type vt100
user-interface
Syntax
user-interface [ type ] first-number [ last-number ]
View
System view
Default Level
2: System level
Parameters
type: User interface type.
first-number: User interface index, which identifies the first user interface to be configured.
last-number: User interface index, which identifies the last user interface to be configured.
Description
Use the user-interface command to enter one or more user interface views to perform configuration.
Examples
# Enter VTY 0 user interface view.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] user-interface vty 0
To Next Page
Loading...
Need help?
General