EasyManuals Logo

H3C S5120-SI Series Command Reference

H3C S5120-SI Series
910 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #30 background imageLoading...
Page #30 background image
1-15
H3C S5120-SI switch series supports the even, none, and odd check modes only. To establish the
connection again, you need to modify the configuration of the termination emulation utility running on
your PC accordingly.
Examples
# Set to perform mark checks.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] user-interface aux 0
[Sysname-ui-aux0] parity mark
protocol inbound
Syntax
protocol inbound { all | ssh | telnet }
View
VTY interface view
Default Level
3: Manage level
Parameters
all: Supports both Telnet protocol and SSH protocol.
ssh: Supports SSH protocol.
telnet: Supports Telnet protocol.
Description
Use the protocol inbound command to configure the user interface to support specified protocols.
Both Telnet and SSH protocols are supported by default.
Related command: user-interface vty.
If you want to configure the user interface to support SSH, to ensure a successful login, you must first
configure the authentication mode to scheme on the user interface. If you set the authentication mode
to password or none, the protocol inbound ssh command will fail. Refer to authentication-mode
.

Table of Contents

Other manuals for H3C S5120-SI Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the H3C S5120-SI Series and is the answer not in the manual?

H3C S5120-SI Series Specifications

General IconGeneral
BrandH3C
ModelS5120-SI Series
CategorySwitch
LanguageEnglish

Related product manuals