1-21
Use the undo lldp notification remote-change enable command to restore the default.
By default, LLDP trapping is disabled on a port.
Examples
# Enable LLDP trapping for GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] lldp notification remote-change enable
lldp timer notification-interval
Syntax
lldp timer notification-interval interval
undo lldp timer notification-interval
View
System view
Default level
2: System level
Parameters
interval: Interval to send LLDP traps, in the range 5 to 3600 (in seconds).
Description
Use the lldp timer notification-interval command to set the interval to send LLDP traps.
Use the undo lldp timer notification-interval command to restore the default.
By default, the interval to send LLDP traps is 5 seconds.
Examples
# Set the interval to send LLDP traps to 8 seconds.
<Sysname> system-view
[Sysname] lldp timer notification-interval 8
lldp timer reinit-delay
Syntax
lldp timer reinit-delay delay
undo lldp timer reinit-delay
View
System view
Default level
2: System level
To Next Page
Loading...
Need help?
General