H3C S5120-SI Series

1-8
View
Any view
Default Level
2: System level
Parameters
verbose: Displays detailed information.
Description
Use the display device command to display information about the device.
Examples
# Display information of the device. (The output of this command varies with devices.)
<Sysname> display device
SubSNo PortNum PCBVer FPGAVer CPLDVer BootRomVer AddrLM Type State
0 52 Ver.B NULL 001 119 IVL LS51LTSS Normal
Table 1-3 display device command output description
Field Description
SubSNo Number of the slot in which the subcard resides
PortNum Maximum number of ports that a subcard supports
AddrLM Address learning mode
Brd Status
Card status, which can be the following values:
z Absent: No card is in the slot.
z Fault: Error occurred, and the card cannot start normally.
z Normal: The card is an interface card and functions
normally.
display device manuinfo
Syntax
display device manuinfo
View
Any view
Default Level
3: Manage level
Parameters
None
Description
Use the display device manuinfo command to display electrical label information about the device.