1-21
Parameters
ip-address: Specifies a source address for the IGMP reports sent by the IGMP Snooping proxy, which
can be any legal IP address.
current-interface: Specifies the IP address of the current VLAN interface as the source address of
IGMP reports sent by the IGMP Snooping proxy. If no IP address has been assigned to the current
VLAN interface, the default IP address 0.0.0.0 is used.
Description
Use the igmp-snooping report source-ip command to configure the source IP address of the IGMP
reports sent by the IGMP snooping proxy.
Use the undo igmp-snooping report source-ip command to restore the default.
By default, the source IP address of the IGMP reports sent by the IGMP snooping proxy is 0.0.0.0.
Note that:
z Before configuring this command in a VLAN, enable IGMP snooping in the VLAN.
z The source IP address configured in the igmp-snooping report source-ip command also applies
when the simulated host sends IGMP reports.
Related commands: igmp-snooping enable.
Examples
# Enable IGMP Snooping in VLAN 2 and configure the source IP address of IGMP reports sent by the
IGMP Snooping proxy in VLAN 2 to 10.1.1.1.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enable
[Sysname-vlan2] igmp-snooping report source-ip 10.1.1.1
igmp-snooping router-aging-time
Syntax
igmp-snooping router-aging-time interval
undo igmp-snooping router-aging-time
View
VLAN view
Default Level
2: System level
Parameters
interval: Dynamic router port aging time, in seconds. The effective range is 1 to 1,000.
To Next Page
Loading...
Need help?
General