H3C S5120-SI Series Command Reference

1-5
Field Description
Port operating status varies with devices.
Port IEEE class
PD power class: 0, 1, 2, 3, 4, and -
- indicates not supported.
Port Detection Status
Power detection state of a PoE interface:
z disabled: The PoE function is disabled.
z searching: The PoE interface is searching
for the PD.
z delivering-power: The PoE interface is
supplying power for the PD.
z fault: There is a fault defined in 802.3af.
z test: The PoE interface is under test.
z other-fault: There is a fault other than
defined in 802.3af.
z pd-disconnect: The PD is disconnected.
Port Power Mode
Power mode of a PoE interface:
z signal: Power is supplied over signal cables.
z spare: Power is supplied over spare cables.
Port Current Power
Current power of a PoE interface, including PD
consumption power and transmission loss.
Port Average Power Average power of a PoE interface
Port Peak Power Peak power of a PoE interface
Port Max Power Maximum power of a PoE interface
Port Current Current of a PoE interface
Port Voltage Voltage of a PoE interface
Port PD Description
Description of the PD connected to the PoE
interface, which is used to identify the type and
location of the PD.
# Display the state of all PoE interfaces.
<Sysname> display poe interface
Interface Status Priority CurPower Operating IEEE Detection
(W) Status class Status
GE1/0/1 enabled low 4.4 on 1 delivering-power
GE1/0/2 enabled critical 0.0 on - disabled
GE1/0/3 enabled low 0.0 on - disabled
GE1/0/4 enabled critical 0.0 on - searching
GE1/0/5 enabled low 4.0 on 2 delivering-power
GE1/0/6 enabled low 0.0 on - disabled
GE1/0/7 disabled low 0.0 off - fault
--- 2 port(s) on, 8.4(W) consumed, 361.6(W) Remaining ---
Table 1-3 display poe interface command output description
Field Description
Interface Shortened form of a PoE interface

H3C S5120-SI Series Specifications

General

Brand	H3C
Model	S5120-SI Series
Category	Switch
Language	English