H3C S5120-SI Series Command Reference

1-4
Parameters
interface-type interface-number: Specifies an interface by its type and number.
Description
Use the display poe interface command to display the power information of the specified interface.
If no interface is specified, the power information of all PoE interfaces is displayed.
Examples
# Display the power state of GigabitEthernet 1/0/1.
<Sysname> display poe interface gigabitethernet 1/0/1
Port Power Enabled : enabled
Port Power Priority : critical
Port Operating Status : on
Port IEEE Class : 1
Port Detection Status : delivering-power
Port Power Mode : signal
Port Current Power : 11592 mW
Port Average Power : 11610 mW
Port Peak : 11684 mW
Port Max Power : 30000 mW
Port Current : 244 mA
Port Voltage : 51.7 V
Port PD Description : IP Phone For Room 101
Table 1-2 display poe interface ethernet command output description
Field Description
Port Power Enabled
PoE state: enabled/disabled
z enabled: PoE is enabled.
z disabled: PoE is disabled.
Port Power Priority
Power priority of the PoE interface:
z critical (highest)
z high
z low
Port Operating Status
Operating state of a PoE interface:
z off: PoE is disabled.
z on: Power is supplied for a PoE interface
normally.
z power-lack: The guaranteed remaining
power of the PSE is not high enough to
supply power for a critical PoE interface.
z power-deny: The PSE refuses to supply
power. The power required by the powered
device (PD) is higher than the configured
power.
z power-itself: The external equipment is
supplying power for itself.
z power-limit: The PSE is supplying a limited
power. The power required by the PD is
higher than the configured power and the
PSE still supplies the configured power.

H3C S5120-SI Series Specifications

General

Brand	H3C
Model	S5120-SI Series
Category	Switch
Language	English