1-4
<Sysname> display fib 10.2.1.1
Destination count: 1 FIB entry count: 1
Flag:
U:Useable G:Gateway H:Host B:Blackhole D:Dynamic S:Static
R:Relay
Destination/Mask Nexthop Flag OutInterface InnerLabel Token
10.2.1.1/32 127.0.0.1 UH InLoop0 Null Invalid
For description about the above output, refer to Table 1-1.
display icmp statistics
Syntax
display icmp statistics
View
Any view
Default Level
1: Monitor level
Parameters
None
Description
Use the display icmp statistics command to display ICMP statistics.
Related commands: display ip interface in IP Addressing Commands; reset ip statistics.
Examples
# Display ICMP statistics.
<Sysname> display icmp statistics
Input: bad formats 0 bad checksum 0
echo 5 destination unreachable 0
source quench 0 redirects 0
echo reply 10 parameter problem 0
timestamp 0 information request 0
mask requests 0 mask replies 0
time exceeded 0
Output:echo 10 destination unreachable 0
source quench 0 redirects 0
echo reply 5 parameter problem 0
timestamp 0 information reply 0
mask requests 0 mask replies 0
time exceeded 0
To Next Page
Loading...
Need help?
General