NEC Univerge SV9100 - Table

Issue 4.0
2-96 Program 11 : System Numbering
Step 2: Specify the length of the code you want to change
After you specify a single- or two-digit code, you must tell the system how many digits comprise the
code. This is the Number of Digits Required column in the Table 2-3 System Numbering Default
Settings on page 2-97 table.
Step 3: Assign a function to the code selected
After entering a code and specifying its length, you must assign its function. This is the Dial Type column
in the Table 2-3 System Numbering Default Settings on page 2-97 table. The choices are:
Input Data
Dial
Types
Dial Type Description Related Program
0
None
1
Service Code
11-10 : Service Code Setup (for System Administrator)
11-11 : Service Code Setup (for Setup/Entry Operation)
11-12 : Service Code Setup (for Service Access)
11-13 : Service Code Setup (for Contact Center)
11-14 : Service Code Setup (for Hotel)
11-15 : Service Code Setup, Administrative (for Special
Access)
11-16 : Single Digit Service Code Setup
2
Extension Number
11-02 : Extension Numbering
11-04 : Virtual Extension Numbering
11-06 : ACI Extension Numbering
11-07 : Department Group Pilot Numbers
11-08 : ACI Group Pilot Number
11-17 : Group Pilot Number
3
Trunk Access Code
11-09-01 : Trunk Access Code
4
Special Trunk Access
11-09-02 : Trunk Access Code
5
Operator Access
20-17 : Operator Extension
6
ARS/F-Route Access
44-xx
8
Networking System
Access
9
Dial Extension Analyze
11-20 : Dial Extension Analyze Table
 Changing the Dial Type for a range of codes can have a dramatic affect on how your system
operates. Assume, for example, the site is a hotel that has room numbers from 100-399. To make
extension numbers correspond to room numbers, you should use Program 11-02 to reassign
extension numbers on each floor from 100 to 399. (Other applications might also require you to
change entries in Program 11-10 ~ 11-16.)