Issue 4.0
SV9100 Programming Manual 2-489
Description
Use Program 35-02 : SMDR Output Options to set the SMDR (Station Message Detail Recording)
output options. Refer to the following chart for a description of each option, its range and default setting.
Program 35 : SMDR Account Code Setup
35-02 : SMDR Output Options
Level:
IN
Item
No.
Item Input Data Default
01
Toll Restricted Call
SMDR can include or exclude calls blocked by Toll
Restriction.
0 = Not Displayed
1 = Displayed
1
02
PBX Calls
When the system is behind a PBX, SMDR can include all
calls (1), or just calls dialed using the PBX trunk access
code (0).
0 = Not Displayed
1 = Displayed
1
03
Trunk Number or Name
Select whether the system should display the trunk
number or the name on SMDR reports.
If this option is set to 1, Program 35-02-14
must be set to 0.
0 = Name
1 = Number
1
04
Summary (Daily)
Set to 1 to have the SMDR report provide a daily
summary (at midnight every night).
0 = Not Displayed
1 = Displayed
1
05
Summary (Weekly)
Set to 1 to have the SMDR report provide a weekly
summary (every Saturday at midnight).
0 = Not Displayed
1 = Displayed
1
06
Summary (Monthly)
Set to 1 to have the SMDR report provide a monthly
summary (at midnight on the last day of the month).
0 = Not Displayed
1 = Displayed
1
07
Toll Charge Cost
Set to 1 to have the SMDR report include toll charges.
0 = Not Displayed
1 = Displayed
1
08
Incoming Call
Enable this option (1) to have the SMDR report include
incoming calls. If you disable this option (0), incoming
calls do not print.
0 = Not Displayed
1 = Displayed
1
To Next Page
Loading...
