NEC Univerge SV9100 - Page 530

Issue 4.0
2-490 Program 35 : SMDR Account Code Setup
09
Extension Number or Name
Set to 1 to have the SMDR report include extension
numbers. Set to 0 to have the SMDR report include
extension names.
0 = Name
1 = Number
1
10
All Lines Busy (ALB) Output
Determine if the All Lines Busy (ALB) indication should
be displayed.
0 = Not Displayed
1 = Displayed
0
11
Walking Toll Restriction Table Number
0 = Not Output
1 = Output
1
12
DID Table Name Output
Determine if the DID table name should be displayed.
0 = Not Displayed
1 = Displayed
0
13
CLI Output When DID to Trunk
Determine if the CLI output should be displayed for DID.
0 = Not Displayed
1 = Displayed
0
14
Date
Determine whether or not the date should be displayed
on SMDR reports.
 This option must be set to 0 if the trunk name is
set to be displayed in Program 35-02-03.
0 = Not Displayed
1 = Displayed
0
15
CLI/DID Number Switching
Determine if the CLI or DID Number Switching should be
displayed.
0 = CLI (CLIP)
1 = DID Calling
Number
2 = CID Name
0
16
Trunk Name or Received Dialed Number
Determine how the SMDR should print incoming calls on
ANI/DNIS or DID trunks. If set to 1, ANI/DNIS trunks can
print DNIS digits. If set to 0 trunk names are printed
instead.
(With V5000 or higher, option “2” is available)
0 = Trunk Port Name
1 = Received Dialed
Number
2 = Both
0
17
Print Account Code or Caller Name of Incoming Call
Determine if SMDR should print Account Code or Caller
Name of Incoming Call.
0 = ACC
1 = CNAME
0
18
Print Mode for Caller Name of Incoming Call
Determine how SMDR should print Caller Name of
Incoming Call.
0 = Normal
1 = Line Feed
0
21
S-Point Terminal Number
0 = MSN Number
1 = Extension
Number
0
22
Security Auto Dialing
0 = No Output
1 = Output
0
23
Watch Auto Dialing
0 = No Output
1 = Output
0
Item
No.
Item Input Data Default