NEC Univerge SV9100 - ID Setup for IP Trunk

Issue 4.0
2-176 Program 14 : Trunk, Basic Setup
Description
Use Program 14-11 : ID Setup for IP Trunk to set the ID of each IP Trunk. This program refers to
incoming and outgoing IP Trunk calls. The ID is sent on an outgoing IP Trunk call. This program is used
only for H.323.
Conditions
 This Data is called IP trunk outgoing call, or IP trunk incoming call.
 This ID is notified at IP trunk outgoing call.
 It is not notified when ID is 0.
 Incoming Call arrives to the trunk port of the same ID as ID notified from the partner system.
Feature Cross Reference

IP Trunk – H.323
Program 14 : Trunk, Basic Setup
14-11 : ID Setup for IP Trunk
Level:
IN
Input Data
Trunk Port Number 001~400
Item
No.
Item Input Data Default
01
IP Trunk ID
0~65535
(0 = No setting)
0