NEC Univerge SV9100 - Internal Paging Group Settings

Issue 4.0
2-458 Program 31 : Paging Setup
Description
Use Program 31-03 : Internal Paging Group Settings to assign names to Internal Paging Groups (i.e.,
Page Zones) and to define the splash tone for Internal Paging.
The system shows the names you program on the telephone display. Use the following chart when
entering and editing text. When using the keypad digits, press the key once for the first character, twice
for the second character, etc. For example, to enter a C, press 2 three times. Press 2 six times to display
the lower case letter.
Program 31 : Paging Setup
31-03 : Internal Paging Group Settings
Level:
IN
Table 2-12 Keys for Entering Names
Key for Entering Names
When entering names in the procedures below, refer to this chart. Names can have up to 12 digits.
Use this keypad
digit . . .
When you want to. . .
1 Enter characters:
1 @ [ ¥ ] ^ _ ` { | }
  Á À Â Ã Ç É Ê ì ó
2 Enter characters: A-C, a-c, 2.
3 Enter characters: D-F, d-f, 3.
4 Enter characters: G-I, g-i, 4.
5 Enter characters: J-L, j-l, 5.
6 Enter characters: M-O, m-o, 6.
7 Enter characters: P-S, p-s, 7.
8 Enter characters: T-V, t-v, 8.
9 Enter characters: W-Z, w-z, 9.
0 Enter characters:
0 ! “ # $ % & ’ ( ) ô Õ ú ä ö ü

 Enter characters:
 + , - . / : ; < = > ? π Σ  Ω ∞ ¢ £