NEC Univerge SV9100 - VRS Delay Announcement

Issue 1.0
2-514 Program 41 : ACD Setup
Description
Use Program 41-11 : VRS Delay Announcement to assign the VRS message number to use as the
message source for the 1st and 2nd Delay Announcement Messages. Refer to Program 41-08 for more
on setting up the overflow options.
This program is activated when the delay announcement source and options are assigned as VRS in
Program 41-08-03.
Program 41 : ACD Setup
41-11 : VRS Delay Announcement
Level:
SA
Input Data
Group No. 01~64
Item
No.
Item Input Data Default
01
Delay Message Start Timer
Input the time before the 1st Delay Message Starts.
0~64800 (sec)
0
02
1st Delay Message Number
Input the VRS Message to be played as the 1st Delay
Message.
0~101
0 = No Message
101 = Fixed Message
0
03
1st Delay Message Sending Count
Input the number of times the 1st Delay Message is sent.
If set to 0, the message is not played.
0~255
0
04
2nd Delay Message Number
Input the VRS Message to be played as the 2nd Delay
Message.
0~101
0 = No Message
101 = Fixed Message
0
05
2nd Waiting Message Sending Count
Input the number of times the 2nd Delay Message is sent.
If set to 0, the message is not played.
0~255
0
06
Tone Kind at Message Interval
Input what is heard between the Delay messages.
0 = Ring Back Tone
1 = MOH Tone
2 = BGM Source
0
07
Forced Disconnect Time after the 2nd Delay Message
Set the time, after the last 2nd Delay Message is played,
before the call is disconnected.
0~64800 (sec)
(0 = No Disconnect)
60