NEC Univerge SV9100 - Call Forward Split Settings

Issue 4.0
2-400 Program 24 : Hold/Transfer Setup
Description
Use Program 24-09 : Call Forward Split Settings to assign Call Forwarding Type and the destination
number for each extension/virtual extension. The destination can have up to 24 digits, using 0~9,
, #,
and P (P is a pause used for analog trunks). Be sure to include the trunk access code (e.g., 9) in the
number if the destination is off-premise.
Program 24 : Hold/Transfer Setup
24-09 : Call Forward Split Settings
Level:
IN
NOTE

A pause for analog trunks can be assigned by pressing Line Key 1.
Input Data
Extension Number 001 ~ 960
Item
No.
Input Data Default
01
Call Forwarding Type:
0 = Call Forwarding Off
1 = Call Forwarding with both ring
2 = Call Forwarding when no answer
3 = Call Forwarding all calls
4 = Call Forwarding busy or no answer
5 = Call Forwarding when busy
0
02
CO Call Forwarding Destination for Both Ring, All Call, No Answer:
0~9, #,
, R, and P
(Up to 24 digits)
No
Setting
03
Intercom Call Forwarding Destination for Both ring, All Call, No Answer:
0~9, #,
, R, and P
(Up to 24 digits)
No
Setting
04
CO Call Forwarding Busy Destination:
0~9, #,
, R, and P
(Up to 24 digits)
No
Setting
05
Intercom Call Forwarding Busy Destination:
0~9, #,
, R, and P
(Up to 24 digits)
No
Setting