NEC Univerge SV9100 - Account Code Setup

Issue 4.0
2-492 Program 35 : SMDR Account Code Setup
Description
Use Program 35-05 : Account Code Setup to set various Account Code options for an extension Class of
Service. Assign a Class of Service to extensions in Program 20-06.
Program 35 : SMDR Account Code Setup
35-05 : Account Code Setup
Level:
IN
Input Data
Class of Service Number 01~15
Item
No.
Item Input Data Default
01
Account Code Mode
Select the Account Code Mode (0~3).
0 = Account Codes Disabled (None)
1 = Account Codes optional
2 = Account Codes Required but not
verified (No verify)
3 = Account Codes Required and
Verified (Verify)
0
02
Forced Account Code Toll Call
Setup
Enable Account Codes for all calls or
just toll calls (for mode 2 or 3 in Item
01 above).
0 = Account Codes for toll and local calls
All)
1 = Account Codes just for toll calls
(STD)
0
03
Account Codes for Incoming Calls
Allow users to enter Account Codes
for incoming calls. If disabled, any
code entered dials out on the
connected trunk.
0 = Account Codes for incoming calls
disabled (No)
1 = Account Codes for incoming calls
enabled (Yes)
0
04
Hiding Account Codes
Hide or show the Account codes on a
telephone display.
0 = Account Codes not displayed
1 = Account Codes displayed
1