Issue 4.0
2-818 Program 90 : Maintenance Program
Description
Use Program 90-05 : Slot Control to reset or delete (uninstall) blades (slots 1~24).
Delete allows you to completely uninstall the blade.
You should do this if you want to remove a blade and
plug it into a different slot and still retain the port assignments. If a different type of interface blade is
being installed in a slot previously used (e.g., changing from a LCA to a DLCA blade), the slot should be
deleted (option 1) first before installing the new interface blade.
Reset allows you to send a reset code.
Conditions
When you delete or reset a blade, you must first remove it from its slot then run Program 90-05. When
reusing the slot for another blade, you must plug the blade in or reset the system before the system
can use the slot again.
When you delete or reset a blade, all related programming in Program 10-03-01 is set back to default.
Program 90 : Maintenance Program
90-05 : Slot Control
Level:
IN
This program is available only via telephone programming and not through PC
Programming.
Input Data
NetLink System ID 0 ~ 50 (default = 0)
Input Data
Menu Number
1 = Delete
2 = Reset
3 = Set Busy Out
4 = Reset Busy Out
Item
No.
Item Input Data
01
Slot Control
Slot Number (1~24)
To Next Page
Loading...
