Issue 4.0
SV9100 Programming Manual 2-361
Description
Use Program 22-02 : Incoming Call Trunk Setup to assign the incoming trunk type for each trunk.
There is one item for each Night Service Mode.
Conditions
When connecting to T1 trunks, after changing Program 22-02-01 to match the Telco connected T1
service type, the T1 cable or the T1 blade must be unplugged and then reconnected for the T1 blade
to sync.
When the trunk type is set to 3 (DID), the DID Transfer to Destination in 22-11-04 for each DID feature
is not supported. This feature is supported only for DID trunks when assigned as VRS.
When the trunk type is set to 3 (DID), the DID Intercept Destination feature for each DID is not
supported. This feature is supported only for DID trunks assigned as VRS.
Program 22 : Incoming Call Setup
22-02 : Incoming Call Trunk Setup
Level:
IN
Input Data
Trunk Port Number 001~400
Item
No.
Day/
Night
Mode
Incoming Type Default Description
Related
Program
01 1~8
0 = Normal
1 = VRS (second dial
tone if no VRS
installed)
2 = DISA
3 = DID
4 = DIL
5 = E&M Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID(DDI) Mode
Switching
0
Set the feature type for the
trunk you are programming.
14-04
To Next Page
Loading...
