NEC Univerge SV9100 - Program 26: ARS Service; Automatic Route Selection Service

SV9100 Programming Manual 2-425
Program: 26
Description
Use Program 26-01 : Automatic Route Selection Service to define the system options for Automatic
Route Selection (ARS).
Program 26 : ARS Service
26-01 : Automatic Route Selection Service
Level:
IN
Input Data
Item
No.
Item Input Data Default
Related
Programming
01
ARS Service
Enable/Disable ARS.
0 = Disable (Off)
1 = Enable (On)
0 26-02
26-03
26-04
02
Network Outgoing InterDigit ARS Time
With Networking, this time replaces 20-03-04
when determining if all network protocol digits
have been received. If ARS is enabled at Site
B, this time can be programmed for 5 (500ms)
at Site A. If ARS is disabled and Site B is using
F-Route for outbound dialing, this time should
be programmed for 30 (three seconds) at Site
A.
0~64800 (sec)
(in 0.1 second
increments)
30 20-03-04
03
ARS Misdialed Number Handling
If a user dials a number not programmed in
ARS, this option determines if the system
should route over Trunk Group 1 or play error
tone.
0 = Route to Trunk
Group 1
1 = Play Warning Tone
to Dialer
0 21-02
06
Class of Service Match Access
0 = Disable (Off)
1 = Enable (On)
0 26-02
07
F-Route Access COS Reference
0 = F-Route
1 = ARS
0 26-02
44-05
08
DT800/DT700 Multi Log-on for ARS
0 refers to PRG 26-04
1 refers to PRG 26-13
0 = Disable (Off)
1 = Enable (On)
0 26-04
26-13