NEC Univerge SV9100 - Connecting System Settings

Issue 4.0
2-632 Program 50 : Common Channel Interoffice Signaling Service
Description
Use Program 50-02 : Connecting System Settings to define the settings for each CCIS Route ID.
Program 50 : Common Channel Interoffice Signaling
Service
50-02 : Connecting System Settings
Level:
IN
Input Data
CCIS Route ID Route ID 1~8: CCIS via DTI
Route ID 9: CCIS via IAD/GCD-PVAA (IP-CCIS)
Item
No.
Item Description Input Data Default
01
Port Number of Common
Signaling Channel (T1)
Specify the Trunk port to send D-channel
information. This program is available for using DTI
package.
0~400
0
02
Common Signaling
Channel Data Speed
Assignment (T1)
Assign the baud rate of Common Signaling Channel
on DTI package.
0 = 64Kbps
1 = 56Kbps
2 = 48Kbps(1)
3 = 48Kbps(2)
1
03
Originating Point Code Assign the Point Code of own side.
0~16367
0
04
Destination Point Code
(T1)
Assign the Point Code of destination side on the DTI
link.
0~16367
0
05
Calling Name Indication
(T1)
Calling name indication is not sent to destination
party if switch is set to 0.
0 = Disable
1 = Enable
1
06
CCH Package channel
Number
CCT Package Assignment
0 ~ 4
0