NEC Univerge SV9100 - Class of Service Options for DISA;E&M

Issue 4.0
2-276 Program 20 : System Option Setup
Description
Use Program 20-14 : Class of Service Options for DISA/E&M to enable/disable DISA and tie line
Class of Service options. You assign a DISA Class of Service to DISA users in Program 25-09. Assign
tie line Classes of Service in 34-02. Up to 15 DISA/E&M Classes of Service can be defined.
Program 20 : System Option Setup
20-14 : Class of Service Options for DISA/E&M
Level:
IN
IMPORTANT
Analog trunk-to-analog trunk and ISDN trunk-to-ISDN trunk calls are supported by
this program. However, analog trunk-to-ISDN trunk and ISDN trunk-to-analog trunk
calls are NOT supported by this program.
Input Data
Class of Service Number 01~15
Item
No.
Item
Input
Data
Default
COS 1~15
01
First Digit Absorbtion (Delete First Digit Dialed)
For tie lines, enable/disable the ability to absorb (ignore) the first
incoming digit. Use this to make the tie trunk compatible with 3-
and 4-digit tie line service. This option does not apply to DISA.
0 = Off
1 = On
0
02
Trunk Group Routing/ARS Access
Enable/Disable a DISA or tie trunk caller ability to dial 9 for Trunk
Group Routing or Automatic Route Selection (ARS).
0 = Off
1 = On
1
03
Trunk Group Access
Enable/Disable a DISA or tie trunk caller ability to access trunk
groups for outside calls (Service Code 704).
0 = Off
1 = On
1
04
Outgoing System Speed Dial
Enable/Disable a DISA or tie trunk caller ability to use the System
Speed Dialing.
0 = Off
1 = On
0
05
Operator Calling
Enable/Disable a DISA or tie trunk caller ability to dial 0 for the
telephone system operator.
0 = Off
1 = On
1