NEC Univerge SV9100 - DID Translation Number Conversion

Issue 4.0
2-374 Program 22 : Incoming Call Setup
Description
Use Program 22-11 : DID Translation Table Number Conversion to specify for each Translation
Table entry (4000).
 The digits received by the system (eight maximum)
 The extension the system dials after translation (24 digits maximum)
 The name that should show on the dialed extension display when it rings (12 characters maximum)
 The Transfer Target – 2 and 3
 Operation Mode
Use the following chart when entering and editing text for names. Press the key once for the first
character, twice for the second character, etc. For example, to enter a C, press 2 three times.
Program 22 : Incoming Call Setup
22-11 : DID Translation Number Conversion
Level:
SA
NOTE

If the Transfer Targets are busy or receive no answer, those calls are transferred to the
final transfer destination (Program 22-10).
Table 2-9 Keys for Entering Names
Key for Entering Names
When entering names in the procedures below, refer to this chart. Names can have up to 12
digits.
Use this keypad digit . . . When you want to. . .
1 Enter characters:
1 @ [¥] ^ _ ` {|}
  Á À Â Ã Ç É Ê ì ó
2 Enter characters: A-C, a-c, 2.
3 Enter characters: D-F, d-f, 3.
4 Enter characters: G-I, g-i, 4.
5 Enter characters: J-L, j-l, 5.
6 Enter characters: M-O, m-o, 6.
7 Enter characters: P-S, p-s, 7.