NEC Univerge SV9100 - Extension Data Swap

Issue 4.0
SV9100 Programming Manual 2-897
Description
Use Program 92-04 : Extension Data Swap to swap data between two extensions.
The following table lists Programs that use the Extension Data Swap function.
Program 92 : Copy Program
92-04 : Extension Data Swap
Level:
IN
NOTE

This program is available only via telephone programming and not through PC
Programming.
Input Data
Item
No.
Item Input Data
01
1st Extension Number
Up to eight characters.
02
2nd Extension Number
Program
Number
Program Name
11-02 Extension Numbering
12-05 Night Mode Group Assignment for Extensions
13-03 Abbreviated Dial Group Assignment for Extensions
13-06 Station Abbreviated Dial Number and Name
15-01 Extension Basic Data Setup
15-02 Multi-Line Telephone Basic Data Setup
15-03 Single Line Telephone Basic Data Setup
15-06 Trunk Access Map for Extension
15-07 Programmable Function Key
15-08 Incoming Virtual Extension Ring Tone Setup
15-09 Virtual Extension Ring Assignment
15-10 Incoming Virtual Extension Ring Tone Order Setup