NEC Univerge SV9100 - DTMF Tone Receiver Setup

Issue 4.0
SV9100 Programming Manual 2-693
Description
Use Program 80-10 : DTMF Tone Receiver Setup to set various data for the DTMF signal detection.
Program 80 : Basic Hardware Setup for System
80-10 : DTMF Tone Receiver Setup
Level:
MF
Input Data
DTMF Tone Receiver Type Number
1 = DTMF Receiver for Extension
2 = DTMF Receiver for Trunk
3 = Reserved
4 = Reserved
5 = Reserved
Item
No.
Item Input Data
01
Detect Level
0 = 0dBm ~ -25dBm
1 = -5dBm ~ -30dBm
2 = -10dBm ~ -35dBm
3 = -15dBm ~ -40dBm
4 = -20dBm ~ -45dBm
5 = -25dBm ~ -50dBm
6 = -30dBm ~ -55dBm
02
Start delay time
0~255 (0.25step, 0ms~64ms)
03
Min. detect level
0~15
DTMF Tone 1 : -15dBm(0) to -30dBm(15)
DTMF Tone 2 : -20dBm(0) to -35dBm(15)
DTMF Tone 3 : -25dBm(0) to -40dBm(15)
DTMF Tone4 : -30dBm(0) to -45dBm(15)
DTMF Tone 5 : -35dBm(0) to -50dBm(15)
04
Max. detect level
0~15
DTMF Tone 1 : -5dBm(0) to -20dBm(15)
DTMF Tone 2 : -10dBm(0) to -25dBm(15)
DTMF Tone 3 : -15dBm(0) to -30dBm(15)
DTMF Tone 4 : -20dBm(0) to -35dBm(15)
DTMF Tone 5 : -25dBm(0) to -40dBm(15)
DTMF Tone 6 : -30dBm(0) to -45dBm(15)
05
Twist level
0~9 (1dB~10dB)