NEC Univerge SV9100 - Program 45: Voice Mail Integration; Voice Mail Integration Options

SV9100 Programming Manual 2-565
Program: 45
Description
Use Program 45-01 : Voice Mail Integration Options to customize certain voice mail integration options.
Program 45 : Voice Mail Integration
45-01 : Voice Mail Integration Options
Level:
IN
Input Data
Item
No.
Item Input Data Default
01
Voice Mail Department Group Number
Assign Extension (Department) Group number as
the voice mail group.
0~64
0 = No Voice Mail
0
02
Voice Mail Master Name
Enter the Voice Mail Master Name.
Up to 12 Characters
VOICE
MAIL
03
Voice Mail Call Screening
Enable/Disable the ability to process the Call
Screening commands (1+ extension number) sent
from the Voice Mail. You should normally enable this
option to allow for Voice Mail Call Screening. Disable
this option if your system has been modified so that
extensions begin with the digit 1 (e.g., 101, 102,
etc.).
0 = Off
1 = On
0
04
Park and Page
Enable/Disable the system ability to process the
Voice Mail Park and Page () commands. You
should normally enable this option.
0 = Off
1 = On
1
05
Message Wait
Enable/Disable the system ability to process the
Voice Mail Message Wait (
#) commands. You
should normally enable this option. If enabled, be
sure that the programmed Message Notification
strings don’t contain the code for trunk access.
0 = Off
1 = On
1
06
Record Alert Tone Interval Time
Set the time between Voice Mail Conversation
Record alerts.
0~64800 (sec)
30
07
Centralized Voice Mail Pilot Number
Assign this number the same as the extension
number or pilot number.
Dial (up to eight
digits)
No Setting