NEC Univerge SV9100 - Restore Recovery Data

Issue 4.0
2-878 Program 90 : Maintenance Program
Description
Use Program 90-58 : Restore Recovery Data to select the recovery data stored in the flash memory of
the GCD-CP10. After this command is executed, the system restarts automatically.
Conditions
None
Feature Cross Reference
None
Program 90 : Maintenance Program
90-58 : Restore Recovery Data
Level:
IN
NOTE

This program is available only via telephone programming and not through PC
Programming.
Input Data
Data ID 1~5
Item
No.
Item Input Data
01
Restore Recovery Data
[Restore & Reset?] : Dial 1+ press Transfer
(Press Transfer to cancel.)