SV9100 Programming Manual 2-359
Program: 22
Description
Use Program 22-01 : System Options for Incoming Calls to define the system options for incoming
calls.
Program 22 : Incoming Call Setup
22-01 : System Options for Incoming Calls
Level:
IN
Input Data
Item
No.
Item Input Data Default Description
Related
Program
01
Incoming Call
Priority
0 = Intercom Call
Priority
1 = Trunk Call
Priority
1
Determine if Intercom calls or trunk
calls have answer priority when both
are ringing simultaneously.
15-02-22
02
Incoming Call
Ring No Answer
Alarm
0 = Disable (Off)
1 = Enable (On)
0
If enabled, an incoming call that rings
longer than the Ring No Answer Alarm
(22-01-03), changes to a unique ring
cadence to indicate that the call has
been ringing too long. If disabled, this
does not occur.
22-01-03
22-01-04
03
Ring No Answer
Alarm Time
0~64800 (sec)
60
If a trunk rings a multiline telephone
longer than this time, the system
changes the ring cadence. This
indicates to the user that the call has
been ringing too long.
22-01-02
04
DIL No Answer
Recall Time
0~64800 (sec)
0
A DIL that rings its programmed
destination longer than this time diverts
to the DIL No Answer Ring Group (set
in Program 22-08).
05
--- Not Used ---
06
DID Ring-
No-Answer Time
0~64800 (sec)
20
In systems with DID Ring-No-Answer
Intercept, this sets the Ring-No-Answer
time. This is the time a DID call rings
the destination extension before
rerouting to the intercept ring group.
22-12
07
DID Incoming
Ring Group No
Answer Time
0~64800 (sec)
20
08
DID Pilot Call No
Answer Time
0~64800 (sec)
60
To Next Page
Loading...
General
