Issue 4.0
SV9100 Programming Manual 2-113
Description
Use Program 11-10 : Service Code Setup (for System Administrator) to customize the Service Codes for
the System Administrator. You can customize additional Service Codes in Programs 11-11~11-16. The
following chart shows:
The number of each code (01~42).
The function of the Service Code.
The type of telephones that can use the Service Code.
The default entry. For example, dialing Item 26 allows users to force a trunk line to disconnect.
Program 11 : System Numbering
11-10 : Service Code Setup (for System Administrator)
Level:
IN
Input Data
Item
No.
Item Terminals Default
Related
Program
01
Night Mode Switching
MLT, SLT 718 12-xx
20-07-01
02
--- Not Used ---
03
Setting the System Time
MLT 728
04
Storing Common Speed Dialing
Numbers
MLT 753
05
Storing Group Speed Dialing
Numbers
MLT 754
06
Setting the Automatic Transfer for
Each Trunk Line
MLT 733 24-04-01
07
Canceling the Automatic Transfer
for Each Trunk Line
MLT 734 24-04-01
08
Setting the Destination for
Automatic Trunk Transfer
MLT 735 24-04-01
09
Charging Cost Display by the
Supervisor
MLT Not Set
10
--- Not Used ---
11
Entry Credit for Toll Restriction
MLT Not Set
To Next Page
Loading...
General
