Issue 4.0
SV9100 Programming Manual 2-111
Description
Use Program 11-09 : Trunk Access Code to assign the trunk access code (normally 9). The trunk access
code can be set from 1~8 digits which is defined to type 3 and 4 in Program 11-01. This is the code
extension users dial to access Automatic Route Selection. The individual Trunk Access Code is used
when Trunk Group Routing is desired for an outgoing line.
Conditions
None
Program 11 : System Numbering
11-09 : Trunk Access Code
Level:
IN
The digit 9 is defined in Program 11-01 as Dial Type 3 with the Number of Digits
Required set to 1. If you change the trunk access code in Program 11-09, you must
make the corresponding changes in Program 11-01.
Input Data
Item
No.
Trunk Access
Code
Description Default Related Program
01
Dial
(Up to four digits)
Assign the trunk access
code (normally 9). This is
the code extension users
dial to access Automatic
Route Selection.
9
11-01 : System Numbering
14-01 : Basic Trunk Data Setup
14-05 : Trunk Group
14-06 : Trunk Group Routing
21-02: Trunk Group Routing for
Extensions
02
2nd Trunk Route
Access Code
Define additional trunk
access codes.
When a user dials the
Alternate Trunk Route
Access Code, the system
routes their call to the
Alternate Trunk Route.
No
Setting
11-01 : System Numbering
14-01 : Basic Trunk Data Setup
14-05 : Trunk Group
14-06 : Trunk Group Routing
21-02 : Trunk Group Routing for
Extensions
21-15 : Individual Trunk Group
Routing for Extensions
To Next Page
Loading...
