NEC Univerge SV9100 - VRS Delayed Message for IRG

Issue 4.0
SV9100 Programming Manual 2-381
Description
Use Program 22-14 : VRS Delayed Message for IRG (Incoming Group Ring) to define for each
incoming ring group the timers, VRS message number and type of tone for VRS Waiting Message.
Program 22 : Incoming Call Setup
22-14 : VRS Delayed Message for IRG
Level:
IN
Input Data
Incoming Ring Group Number 1~100
Item
No.
Item Input Data Default
01
1
st
Delayed Message Start Time
Time before the VRS Delay Message is played for
IRG.
0~64800 (sec)
0
02
1
st
Delayed Message Number
VRS message that is used for the 1st Delayed
Message.
0~101
0 = No Message
101 = Fixed Message
0
03
1
st
Delayed Message Sending Count
This is the number of times the 1st Delay Message
is played. If set to 0, the 1st Delay Message is not
played.
0~255 (time)
0
04
2
nd
Delayed Message Number
VRS message that is used for the 2nd Delayed
Message.
0~101
0 = No Message
101 = Fixed Message
0
05
2
nd
Delayed Message Sending Count
This is the number of times the 2nd Delay
Message is played. If set to 0, the 2nd Delay
Message is not played.
0~255 (time)
0
06
Tone Kind at Message Interval
What is heard between the Delay Messages.
0 = Ring Back Tone
1 = MOH Tone
2 = BGM Source
0
07
Disconnect Time After the End of VRS Delayed
Message
Time, after all 2nd Delay Messages are played,
before the caller is disconnected.
0 = No Disconnect
1~64800 Seconds
60