NEC Univerge SV9100 - Netlink Communication Port Settings

Issue 4.0
SV9100 Programming Manual 2-659
Description
Use Program 51-09 : NetLink Communication Port Settings to set the various communication ports
used on the system.
Program 51 : NetLink Service
51-09 : NetLink Communication Port Settings
Level:
IN
Input Data
Item
No.
Item Input Data Default
01
Primary Waiting Port
Set the communication port that the Primary system uses to
communicate with the Secondary system.
0~65535 58000
02
Communication Waiting Port
Select port used to communicate between nodes. It is always opened
by all nodes.
0~65535 58001
03
Secondary Communication Port
Secondary system communicates with Primary system at this port
number. If 0 is specified, temporary port is dynamically selected.
0~65535 0
04
Primary Search Port
When Fail-Over occurs, each system communicates with other system
at this port number.
If 0 is set, temporary port is dynamically selected.
If 0 is not specified, the number and continuous maximum 50 number is
used.
(Ex. 5000 is specified 5001, 5002…5049 are used).
0~65535 0
05
Primary Detection Port
Enter port number to seek the Top Priority Primary system.
If 0 is specified, temporary port is dynamically selected.
0~65535 0
06
Database Replication Communication Listening Port
Use this port to replicate database.
0~65535 58002
07
Database Replication Primary Detection Port Use
Use this port to replicate database.
If 0 is specified, temporary port is dynamically selected.
0~65535 0