Issue 4.0
2-216 Program 15 : Extension, Basic Setup
Description
Use Program 15-08 : Incoming Virtual Extension Ring Tone Setup to assign a ring tone range (0~4)
to incoming virtual extensions assigned to a Virtual Extension key (Program 15-07). If you enable ringing
for the key in Program 15-09, the key rings with the tone you set in this program. Also see Program 22-
03. The chart below shows the available tones. There are 512 available extension ports.
Program 15 : Extension, Basic Setup
15-08 : Incoming Virtual Extension Ring Tone Setup
Level:
IN
Input Data
Extension Number 001 ~ 960
Item
No.
Incoming Ring Pattern Default Description
01
0 = Tone Pattern 1
1 = Tone Pattern 2
2 = Tone Pattern 3
3 = Tone Pattern 4
4 = Incoming Ring Tone
Extension
5 = Tone Pattern 5
6 = Tone Pattern 6
7 = Tone Pattern 7
8 = Tone Pattern 8
0 = Tone Pattern 1 When an extension or a virtual extension
is assigned to the function key on the
key telephone, select the ring tone when
receiving a call on that key.
For CAR keys, only tone pattern 1 (entry
0) can be used. The remaining patterns
are not checked with this feature.
To Next Page
Loading...
