NEC Univerge SV9100 - External Speaker Control

Issue 4.0
SV9100 Programming Manual 2-463
Description
Use Program 31-06 : External Speaker Control to define the settings for the external speaker using an
amplifier.
Program 31 : Paging Setup
31-06 : External Speaker Control
Level:
IN
Input Data
External Speaker Number 1~9
Item
No.
Item Input Data Default
01
Broadcast Splash Tone Before
Paging (Paging Start Tone)
Enable/Disable splash tone before
Paging over an external zone. If
enabled, the system broadcasts a
splash tone before the External
Paging announcement.
0 = No Tone (None)
1 = Splash Tone
2 = Chime Tone
2
02
Broadcast Splash Tone After
Paging (Paging End Time)
Enable/Disable splash tone after
Paging over an external zone. If
enabled, the system broadcasts a
splash tone at the end of an External
Paging announcement.
0 = No Tone (None)
1 = Splash Tone
2 = Chime Tone
2
03
Speech Path
Determine if the external speaker is
used for talkback (As this option is
not available with the GCD-CP10
external page zone, speaker 9 should
be left at 1).
0 = Both Way (Duplex)
1 = One Way (PGD(2)-U10 ADP
 SPK)
(Simplex)
1
04
CODEC Transmit Gain Setup
1~57 (-15.5 ~ +12.5dB)
32
05
CODEC Receive Gain Setup
1~57 (-15.5 ~ +12.5dB)
32