Issue 4.0
SV9100 Programming Manual 2-165
Description
Use Program 14-02 : Analog Trunk Data Setup to set the basic options for each analog trunk port.
Refer to the table below for a description of each option, its range and default setting.
Program 14 : Trunk, Basic Setup
14-02 : Analog Trunk Data Setup
Level:
IN
Input Data
Trunk Port Number 001~400
Item
No.
Item Input Data Default
Related
Program
01
Signaling Type (DP/DTMF)
Set the signaling type for the trunk.
0 = Dial Pulse (10 PPS)
1 = Dial Pulse (20 PPS)
2 = DTMF
2
02
Ring Detect Type
Set Extended Ring Detect or
Immediate Ring Detect for the trunk.
For T1 loop/ground start trunks, this
option must be set to 1 for the trunks to
ring and light correctly.
0 = Normal/delayed
1 = Immediate Ringing
1
03
Flash Type
Select the flash type (open loop flash
or ground). Always set this option for
open loop flash.
0 = Open Loop Flash
1 = Ground
0
04
Hooking Type
Use Flash for Timed Flash (Program
81-01-14) or Disconnect (Program 81-
01-15). (A user implements Flash by
pressing the FLASH key while on a
trunk call.)
0 = Timed Flash (Hooking)
1 = Disconnect (Cut)
0 81-10-07
81-10-08
05
Dial Tone Detection for Manually
Accessed Trunks
Enable/Disable dial tone detection for
directly accessed trunks. If disabled,
the system outdials on the trunks
without monitoring for dial tone.
0 = Dial Tone Detection Not Used
1 = Dial Tone Detection Used
0 21-01-04
06
Pause at 1st Digit after Line Seize in
Manual Dial Mode
0 = No Pause (No)
1 = Pause (Yes)
1 21-01-06
To Next Page
Loading...
