NEC Univerge SV9100 - VRS Delayed Message for Department Group

Issue 4.0
SV9100 Programming Manual 2-383
Description
Use Program 22-15 : VRS Delayed Message for Department Group to define for each Department
(Extension) Group the timers, VRS message number and tone kind for VRS Delayed Message. There
are 64 available Department Groups.
Program 22 : Incoming Call Setup
22-15 : VRS Delayed Message for Department Group
Level:
IN
Input Data
Extension Group Number 01~64
Item
No.
Item Input Data Default
01
1
st
Delayed Message Start Time
Time before the VRS Delay Message is played for
Department Group.
0~64800 (sec)
0
02
1
st
Delayed Message Number
VRS message that is used for the 1st Delayed
Message.
0~101
0 = No Message
101 = Fixed Message
0
03
1
st
Delayed Message Sending Count
This is the number of times the 1st Delay Message
is played. If set to 0, the 1st Delay Message is not
played.
0~255 (time)
0
04
2
nd
Delayed Message Number
VRS message that is used for the 2nd Delayed
Message.
0~101
0 = No Message
101 = Fixed Message
0
05
2
nd
Delayed Message Sending Count
This is the number of times the 2nd Delay
Message is played. If set to 0, the 2nd Delay
Message is not played.
0~255 (time)
0
06
Tone Kind at Message Interval
What is heard between the Delay Messages.
0 = Ring Back Tone
1 = MOH Tone
2 = BGM Source
0
07
Disconnect Time After the End of VRS Delayed
Message
Time, after all 2nd Delay Messages are played,
before the caller is disconnected.
0 = No Disconnect
1~64800 (sec)
60