NEC Univerge SV9100 - Short Ring Setup; Table 2-18 Frequency 1;2 Table

Issue 4.0
2-690 Program 80 : Basic Hardware Setup for System
Description
Use Program 80-09 : Short Ring Setup to define the short ring tone for SV9100 multiline terminals.
Program 80 : Basic Hardware Setup for System
80-09 : Short Ring Setup
Level:
IN
Input Data
Short Ring Tone 1 = Confirmation
2 = Error
3 = Long conversation warning tone
Item
No.
Item Description Default
01
Frequency 1
Refer to Table 2-18 Frequency 1/2 Table
8 for Confirmation Tone
8 for Error Tone
4 for Long Conversation
Warning Tone
02
Frequency 2
Refer to Table 2-18 Frequency 1/2 Table
8 for Confirmation Tone
8 for Error Tone
4 for Long Conversation
Warning Tone
03
Ring Cycle
Refer to Table 2-19 Ring Cycle Table
1 for Confirmation Tone
14 for Error Tone
14 for Long Conversation
Warning Tone
NOTE

When a single tone is sent, Frequency 1/2 is set to the same value.
Table 2-18 Frequency 1/2 Table
Data Frequency (Hz) Data Frequency (Hz)
01 392 09 880
02 440 10 988