Issue 4.0
SV9100 Programming Manual 2-459
Default
Item 01 : Internal Paging Group Name
#
#
= Accepts an entry (only required if two letters on the same key are
needed - ex: TOM). Pressing
# again = Space. (In system programming
mode, use the right arrow soft key instead to accept and/or add a
space.)
Conf Clear the character entry one character at a time.
Hold Clear all the entries from the point of the flashing cursor and to the right.
Input Data
Internal Paging Group Number 01~64
Item
No.
Item Input Data Default
01
Internal Paging Group Name
Assign name to Internal Paging Groups (i.e., Page
Zones). The system shows the name you program on the
telephone display.
Up to 12 Characters
Refer to default table.
Extension
Paging Group
Name
01 Group 1
02 Group 2
::
64 Group 64
Table 2-12 Keys for Entering Names
Key for Entering Names (Continued)
When entering names in the procedures below, refer to this chart. Names can have up to 12 digits.
Use this keypad
digit . . .
When you want to. . .
To Next Page
Loading...
